Govee permanent outdoor lights

Govee Permanent Lights Repair & Rework

A section went dark, strands are sagging, or the first install was done wrong? We find the fault, replace what failed, and re-mount the run the right way — tape, a bracket, and two screws at every light.

House at night with Govee permanent lights installed along the roofline

Neighbor group deal

Gather your neighbors — save up to $900 together

Book together with 2 neighbors and each home saves:

  • $300 OFF a full-house (all-around) installation
  • $200 OFF front & both sides

Homes over 200 ft of roofline qualify. Already-installed homes don’t count toward a group — new bookings only. $600 minimum per home applies.

Repair & rework

Already have lights up? We fix them

We service Govee permanent lights across Chicago suburbs — including systems we did not install.

Most permanent-light problems are not the whole system dying. A single failed light, a tape-only mount letting go, or a sloppy first install can take down a whole side of the house. We diagnose the actual fault first, then repair, rework, or re-mount only what needs it — and if our own installation work failed inside the 1-year installation warranty, that fix is on us.

Dead section troubleshooting

Govee strands run as a chain: the lights before a failed light keep working, and everything after it goes dark. The first dark light marks the fault — we find it and replace that light or section, not the whole kit.

Rework of a failed install

Bad layout, loose wiring, lights already coming down? We take the run apart and reinstall it to our mounting standard. Priced at $8/ft, with a $600 minimum.

Re-mounting fallen strands

Tape alone lets go in heat and cold — that is why strands sag and fall. We re-mount every light with the factory 3M tape, a bracket, and two screws, in white or black brackets for every Govee family.

Removal of an old install

We remove a permanent-light installation put up by someone else — strands, clips, and wiring — for a flat $400, so the roofline is clean for what comes next.

Repair pricing

Known prices before we start

Rework of a failed installation$8/ft · $600 min
Removal of someone else’s installation$400
Service visit (outside warranty)from $250

Warranty

Our installs are covered

ESHEN installation: if our mounting or wiring fails within the 1-year installation warranty, we come back and fix it.

Equipment: the lights themselves stay under Govee’s manufacturer warranty — claims go through the seller.

How diagnosis works

One bad light can darken half the house

A Govee strand is a chain, not a set of independent bulbs. Power and signal pass from light to light, so when one light fails, every light after it stops working too — while the lights before it stay lit. That pattern is the diagnosis: the first dark light in the run is almost always the failed one.

Replacing that one light or the damaged section brings the rest of the run back. You do not need a new kit, and you do not need to take the whole roofline down. Send us a photo of the dark section and we will tell you the likely fix before anyone climbs a ladder.

Common questions

Govee repair FAQ

Straight answers on the failures we see most. Having a new system installed instead? Compare the Govee models & mounting →

Part of my Govee lights went dark. What happened?

Most likely one light in the strand failed. Govee strands work as a chain — the lights before the failed one keep working, and everything after it goes dark until the bad light is replaced. The first dark light is the one to check. It does not mean buying a whole new kit: we find the fault and replace that light or section.

Can you fix lights that another installer — or I — put up?

Yes. We rework installations done by other installers and DIY installs. Rework is priced at $8 per foot with a $600 minimum: we take the run down where needed and reinstall it to our mounting standard — tape, a bracket, and two screws at every light.

My lights are sagging or falling down. Can you re-mount them?

Yes — that is the most common repair we see. Tape-only mounting lets go in summer heat and winter cold. We re-mount each light three ways: the factory 3M tape, a bracket over the light, and two screws holding the bracket, with white or black brackets for every Govee model family.

What does a service visit cost?

If we installed your lights and our mounting or wiring failed, the visit is covered by our 1-year installation warranty. For systems outside that warranty — including installs done by others — a service visit starts at $250, and the scope is confirmed with you before any work begins.

Can you take down an old permanent-light installation?

Yes. Removal of an installation put up by someone else is a flat $400 — strands, clips, and wiring come down and the roofline is left clean.

Free estimate

Ready to discuss this service?

Fill in the form and send it — we reply within 24 hours.

What to send

  • Photo of the dark or damaged section
  • ZIP code
  • Model of your lights, if known
  • Who installed them — us, another installer, or DIY

Tell us about your project — we reply within 24 hours. Your request goes straight to Arnalbek, owner of ESHEN Home Services.

Photos help us price your project faster. You can also text them to 224-464-1925.

Call 224-464-1925

We reply within 24 hours — usually the same day. No spam, no pressure.

Call 224-464-1925Get Free Estimate
Finished bathroom project preview